But drivers of professional cards from E-MU offer a steep learning curve. A photo of the M-Audio Revolution 5. Usually, you can start a recording program and set the source to wave. A schematic representation of my best guess about the data flow inside the Revolution 5. A double click on the icon in the tray opens control panel, a left click opens a small menu, where you can activate Sensaura or TruSurround. Different output signal levels were demonstrated, when we used different headphones.

Uploader: Kazijinn
Date Added: 18 September 2008
File Size: 7.71 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 20293
Price: Free* [*Free Regsitration Required]

In fact only this card can provide accurate playback of a 16bit signal in the above-mentioned parameters.

m audio revolution 5.1 Thanks to flexible signal routing in DirectWire3. Rvolution these labels are not adequate. But drivers of professional cards from E-MU offer a steep learning curve. It’s not very convenient, if you adjust volume in your sound card instead of an external amplifier. Digital controller Envy24GT 24 bit, kHz; interfaces: Usually, you can start a recording program and set the source to wave.

Unfortunately, its drivers are not free of bugs, and there are no refolution. m audio revolution 5.1

New Drivers  KONICA IP 423 TREIBER

M-Audio Revolution Linux Support

X-Fi drivers did not get rid of latencies and tabbed pages, but they got animated graphics elements, which look more like a slide show on old computers. I tried to find out where each GPIO line leads. M-Audio launched a remake of the M audio revolution 5.1 7. Let’s review the main presets. Front output and headphones signals are different. It was a common situation to have two cards: X-Fi offers less details and worse articulation in low frequencies. M-Audio programmers went wrong with assigning channels.

M-Audio Revolution 5.1 Linux Support

A minimum latency of 64 samples sampling rate: The GPIOs not listed 1, 3, 4, and seem to be unconnected. On the whole, the control panel is good.

As you can see, all cards outperform the reference It allows to maximize a record level, to apply the loudest audio section to the input and then convert it to digital form. The card revolition supported by the ice ALSA driver. The higher the impedance of headphones, the smaller the difference between the levels. Front surround channels are revilution replaced by a separate output for headphones.


Here is a table with results demonstrated by Prodigy7. Amplification is m audio revolution 5.1 for most headphones.

There are only six playback channels in all modes. The card is driven by a Via Envy24GT audio-controller.

M-Audio Revolution

Differences between the cards are reduced at lower volumes. The only driver on the manufacturer’s web site is over two years old. Frequency response did not change, when we measured it with loads of various resistance.

You can choose any configuration of presets in QuickSwich Settings, but only four. Both cards do not m audio revolution 5.1 high frequencies in kHz mode. Rwvolution M-Audio Revolution 5. V denotes volume controls, M denotes the possibility to mute a stream.